Mitsubishi Electric C80 Series Instruction Manual page 110

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation method (Opening the existing machining programs only in the 3rd part system (When the parameter "#1285
ext21/bit2" is set OFF and the 1st part system is set as the displayed part system))
Perform the following procedure to open the machining program, "400", under the following conditions.
The parameter "#8977 Multi-$ simul edit" is set to "1" (valid).
The machining program, "400", is registered in the 3rd part system of NC memory.
(1) Press the menu [Open].
(2) Use the [↑], [↓], [←], and [→] keys to align the cursor
with the target machining program (400), and press
the [INPUT] key.
The same operation can also be performed by input-
ting the machining program name (400) to be edited
in the input section and pressing the [INPUT] key.
(3) Press the [Y] key.
Operation method (Creating a new machining program (When the parameter "#1285 ext21/bit2" is set ON and the 1st
part system is set as the displayed part system))
Perform the following procedure to create a new machining program, "500", under the following conditions.
The parameter "#8977 Multi-$ simul edit" is set to "1" (valid).
The parameter "#1285 ext21/bit2" is set to "1" (to newly create only machining programs in the displayed part system).
(1) Press the menu [Open(New)].
(2) Input the machining program name (500) to be newly
created in the input section, then press the [INPUT]
key.
The list appears as a pop-up window.
The operation message "Create new file? (Y/N)" ap-
pears.
The machining program, "400", is newly created in the
1st part system.
The machining program "400" in the 1st part system is
displayed in the currently selected editing area, and the
machining program "400" in the 3rd part system is dis-
played in the deselected editing area.
The list appears as a pop-up window.
The machining program "500" in the 1st part system is
displayed in the currently selected editing area, and the
machining program opened in the deselected editing
area is closed.
85 IB-1501453-C