Mitsubishi Electric C80 Series Instruction Manual page 218

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Operation method (Changing a group No.)
(1) Press the menu [Grp No.change].
(2) Designate the group No. after changing.
112 [INPUT]
Note
(1) An error occurs if the group No. duplicates a pre-existing group No.
Operation method (Setting the tool life data)
(1)
Move the cursor to the data to be set using the
It is possible to move to the line after the registered line.
Set a tool No. for this line to newly register tool life management data.
(2) Set a value.
20 [INPUT]
Note
(1) The other settings will be invalid when the tool ST (status) setting data are not set.
(2) The same tool cannot be registered in more than one group.
(3) If the tool No. is not set, the other data cannot be set.
(4) Change the "Method" to initialize the related items.
Change the tool life management method (the 1st digit) to clear the "Life" and "Usage", and also change the units.
Change the tool radius compensation data (the 2nd digit) to clear the "Radius Compensation".
Change the tool length compensation data (the 3rd digit) to clear the "Length Compensation".
Figures after the decimal point are also changed in line with the specifications.
Operation method (Copying/pasting the tool life data)
(1) Move the cursor to the line to be copied.
(2) Press the menu [Line copy].
(3) Move the cursor to the line where the data is to be pasted.
(4) Press the menu [Line paste].
Note
(1) It is not possible to paste into a line for which a tool No. has not been set.
(2) Once copied, the data is held until a new data item is copied.
Operation method (Erasing one line of tool life management data)
(1) Move the cursor to the line to be erased.
(2) Press the menu [Line clear] and [INPUT] keys.
(3) Press the [Y] or [INPUT] key.
Press a key other than [Y] or [INPUT] in order not to erase the data.
, , [↑], [↓], [|←] or [→|] key.
193 IB-1501453-C