Mitsubishi Electric C80 Series Instruction Manual page 237

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Operation method (Setting the center and angle of the coordinate rotation)
The setting of the parameters "#8623 Coord rot centr(H)", "#8624 Coord rot centr(V)", and "#8627 Coord rot angle" can be
changed.
(1) Press the menu [Rotate measure].
(2) Press the menu [Rotate center].
(3) Input data in the 1st axis of "Coord center" column.
0 [INPUT]
(4) Input data in the 2nd axis of "Coord center" column.
0 [INPUT]
(5) Press the menu [Rotate center].
Note
(1) Set the angle of the coordinate rotation in the same manner.
Operation method (Carrying out the rotation measurement using touch probe to set the measurement results to the
workpiece coordinate offset)
(1) Press the menu [Rotate measure].
(2) Set the parameter "#8116 Coord rot para invd" to "1"
(invalid).
(3) Turn the manual absolute switch ON.
(4) Set the following parameters to "0".
#8623 Coord rot centr(H)
#8624 Coord rot centr(V)
#8627 Coord rot angle (*1)
(5) Perform the reference position return command, etc.
to position the tool at the basic point.
(6) Turn ON the measurement switch on the machine
operation board.
(7) Referring to "Setting the center shift amount", set the
center shift amount.
This setting is not necessary if the coordinate rotation
center is served as the workpiece coordinate zero
point.
(*1) These parameter should be set to "0" to set the measured value to them.
If the value other than "0" has been set, an error occurs when writing to the coordinate system.
IB-1501453-C
The menu is highlighted and the cursor displays at point
A.
The cursor can be moved to A, B, or C, using the [↑] or
[↓] key.
212