Mitsubishi Electric C80 Series Instruction Manual page 224

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus
Menus
This displays the data of a group when that group No. of tool life management data is set and the [IN-
Group
PUT] key is pressed.
No.
The group No. can be referred to in the group list.
Copies one line of tool life management data where the cursor is located.
Line
copy
The copied tool life management data is written to the data in the line where the cursor is located.
Line
If the copied data is changed after the menu [Line copy] is pressed, the data before changing is written
paste
when pasted.
The copied data can be pasted as many times as is required until new data is copied.
This erases a designated line (multiple lines possible) of tool life management data.
Line
The first and the last line No. of the data to be erased is specified with a "/" separating the Nos..
clear
If the [INPUT] key is pressed without specifying a line, the data in the line where the cursor is located is
erased.
This changes a group No.
Grp No.
If a new group No. is specified and the [INPUT] key pressed, the group No. changes.
change
An error occurs if an existing group No. is specified.
The group active area is changed if parameter "#1107 Tllfsc" is set to "1" or "2".
Group
change
Changes to the multiple group life management data display mode based on the parameter "#1107
Multi
Tllfsc" setting value.
group
This creates a new group and displays the life management data containing no data.
Group
regist
This displays the list of tool life data groups.
Group
list
The multiple group life management data display mode is canceled.
Close
Operation method (Designating a group No.)
(1) Press the menu [Group No].
(2) Designate the group No. to be displayed.
12 [INPUT]
Note
(1) If a group No. that does not exist is set, a message appears to confirm the creation of a new No. A new group is created
if [Y] or [INPUT] is pressed.
When creating a new group, set the method and life data at the end of the group No., separating the data with a "/". If
the method and life data are omitted, a new group is created with method = 0 (usage time), and life data = 0.
Operation method (Changing a group No.)
(1) Press the menu [Grp No.change].
(2) Designate the group No. after changing.
112 [INPUT]
Note
(1) An error occurs if the group No. duplicates a pre-existing group No.
Details
199 IB-1501453-C