Setting A Tool; Registering A Tool (Tool Registration Screen) - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
5Setting a Tool and a Workpiece
This chapter explains the details of tools and workpieces based on respective menus on the setup (Setup) screen.

5.1 Setting a Tool

Refer to the instruction manual issued by the MTB for details on the tool setting.

5.2 Registering a Tool (Tool Registration Screen)

Setup
T-reg
A tool No. is assigned to each tool to make the tools installed on the machine recognizable to the NC on the tool registration
(T-reg) screen of the Setup screen. The tool No. is registered corresponding to the magazine pot and spindle where that
tool is installed, and the standby location.
When the tool No. and magazine pot are changed by a tool selection command or tool replacement command, the new tool
No. is displayed.
When not making an arbitrary setting for the number of registered tools, there are maximum 3 magazines, and up to 120
tools can be registered for each magazines. When making an arbitrary setting, there are a maximum of 5 magazines, and
up to 360 tools can be registered for all magazines.
This function differs depending on the specifications of the MTB. Refer to the instruction manual issued by the MTB for
details.
(1)
(2)
Manual numerical value command can be executed when manual numerical value command window is displayed by input-
ting an address key such as MST, etc.
IB-1501453-C 122
(3)
(4)