Mitsubishi Electric C80 Series Instruction Manual page 280

C80 Series Instruction Manual
7 Setting Machine Movable Area
Setting the barrier position with length (length between P points)
(1) Press the menu [Enter length].
(2) Select whether the barrier to be set is right side or left
side with the menu.
(Example) Press the menu [Left barrier].
(3) Select the chuck type with the menu.
(Example) Press the menu [Chuck type 2].
(4) Input the value to CX.
20.000 [INPUT]
The setting can be performed also by pressing the
menu [=Input] or [+Input] instead of the [INPUT] key.
When the menu [+Input] is pressed, the value ob-
tained by adding the input value to the original value
is set.
(5) Input the values to CZ to W3 in the same way.
Setting the barrier position with coordinates value (distance from the work center coordinates (barrier P0))
(1) Press the menu [Enter coordin].
(2) Select whether the barrier to be set is right side or left
side with the menu.
(Example) Press the menu [Right barrier].
(3) Select the tailstock type with the menu.
(Example) Press the menu [T-stock type 1].
(4) Input the value to P1 X.
30.000 [INPUT]
The setting can be performed also by pressing the
menu [=Input] or [+Input] instead of the [INPUT] key.
When the menu [+Input] is pressed, the value ob-
tained by adding the input value to the original value
is set.
(5) Input the values to P1 Z to P3 Z in the same way.
The mode is switched to the length input mode. The
highlight of the menu [Enter coordin] is canceled and the
[Enter length] is highlighted.
The cursor is displayed at CX, and the length data can
be set.
The display is switched to the menu of the barrier form.
The drawing is switched to the chuck barrier type 2 guide
drawing.
The value "20.000" is set to the cursor position (CX), and
the coordinates value is also updated.
The cursor moves to CZ.
Consistency check is performed for respective setting
data, and an error message is displayed when an illegal-
ity is detected.
The mode is switched to the coordinates input mode.
The highlight of the menu [Enter length] is cancelled and
the menu [Enter coordin] is highlighted.
The cursor is displayed at P1 X, and the coordinates
data can be set.
The display is switched to the menu of the barrier form.
The drawing is switched to the tailstock barrier type 1
guide drawing.
The value "30.000" is set to the cursor position (P1 X),
and the length is also updated.
The cursor moves to P1 Z.
Consistency check is performed for respective setting
data, and an error message is displayed when an illegal-
ity is detected.
255 IB-1501453-C