Messages - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
2 Screen Operations

2.1.3 Messages

The following tables show the messages displayed at the top of the screen.
Operation messages
Display
Select a channel.
Results messages
Display
Connection complete. (*1)
Connection complete. GOT and
CNC language are different. Con-
firm the display language setting.
(*1)
Succeeded in acquiring the opera-
tion right. (*1)
Failed to acquire the operation
right.
Unable to move to the designated
screen.
Unable to move to the designated
system.
The Ethernet settings of the moni-
toring target CNC are not correct.
Unable to do drawing. Use the lat-
est OS.
(*1) These messages do not appear when the parameter "#1251 set23/bit3" (Non-display of completion message (display
unit (GOT))) is set to "1". This parameter is obtained when CNC monitor2 starts to communicate with CNC. The pa-
rameter is valid for the project which is created by "GT Designer3" Ver. 1.195D or later.
State display message
Display
Communication error
Connecting
Right of operation is being ac-
quired.
The file is being accessed.
Another display is being operated. You do not have the exclusive authorization.
The file is being accessed by an-
other display.
Unable to get the operation right
before end of process.
This message appears at the first screen transition after power ON without connec-
tion setting. Select the channel which contains the CNC to connect.
The connection is completed. The monitor screen is displayed.
The connection is completed. The monitor screen is displayed.
However, the display language is different between GOT and CNC. Confirm the
display language setting.
The operation right of CNC is obtained. CNC operations are available.
The operation right of CNC could not be obtained.
The CNC could not transit to the designated screen. The monitor screen is not dis-
played.
Review the drawing data setting. The designated screen may not exist in the CNC
or the CNC designation may be wrong.
The CNC could not transit to the designated part system. The monitor screen is not
displayed.
Review the drawing data setting. The designated part system may not exist in the
CNC.
This message will not be displayed if an error that you cannot transit to the desig-
nated screen is occurring.
The setting of the designated access point cannot be found. Review the drawing
data setting.
Drawing cannot be done because the version of the CNC OS and that of this ap-
plication do not match.
Install the latest OS.
This message appears when the GOT cannot connect to the CNC, or cannot com-
municate with the connected CNC.
Confirm the connection setting and the state of the cables.
When the connection with the CNC is returned, the message "Connection com-
plete" will be displayed.
The connection with the CNC is being performed. Wait for a moment.
The operation right for the CNC is being obtained. Wait for a moment.
The file is being accessed. Wait until it is completed.
The file access such as copying and comparison is being performed between the
CNC and the other display unit. Due to the state that the operation right cannot be
obtained, wait until it is completed.
13
Details
Details
Details
IB-1501453-C