Mitsubishi Electric C80 Series Instruction Manual page 107

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation to select the menu [Edit] - [Open] and open an existing machining program (Case in which the 1st part sys-
tem is set as the displayed part system)
○: Machining program registered
$1 $2 (*1)
○ ○
○ ×
× ○
× ×
(*1) For part systems other than the 1st part system, the 2nd part system is described as a typical one.
(*2) The operation message "Create new file? (Y/N)" appears. If "N" is selected, the message "A file does not exist" ap-
pears, and the target file is not opened. If "Y" is selected while the remaining number of registered machining programs
is "0", the message "Program entry over" appears, and no machining program is displayed.
When the parameter "#1285 ext21/bit2" (Multi-part system program generation and operation) is ON, "Create new file?
(Y/N)" does not appear and the file will not be opened.
Operation to select the menu [Edit] - [Open (New)] and open an existing machining program (Case in which the 1st
part system is set as the displayed part system)
Multi-part system program gen-
eration and operation
(#1285 ext21 bit2)
ON (Newly creates only a machin-
ing program in the displayed part
system.)
OFF (Collectively creates new ma-
chining programs in all the part
systems.)
(*1) For part systems other than the 1st part system, the 2nd part system is described as a typical one.
IB-1501453-C
×: No machining program registered
A programs in the 1st part system is displayed in the currently selected editing area, and
that in the 2nd part system is simultaneously displayed in the deselected editing area.
This displays a machining program in the 1st part system in the currently selected editing
area. Then, if the machining program is opened in the deselected editing area, it is closed.
A confirmation message (*2) is then displayed. Selecting "Y" creates and displays a new
empty file in the 1st part system in the currently selected editing area.
Machining programs in the 2nd part system are displayed in the deselected editing area.
If the designated machining program does not exist in all part systems, the message "Des-
ignated file does not exist" appears, that machining program is not displayed.
This displays machining programs in the 1st part system in the currently selected
editing area.
When machining programs exist in the 2nd part system, they are simultaneously
displayed in the deselected editing area. (*1)
When no machining programs exist in the 2nd part system, the machining programs
opened in the deselected editing area are closed. (*1)
When no machining programs exist in all the part systems, a machining program in
the 1st part system is displayed in the currently selected editing area and a machin-
ing program in the 2nd part system is displayed in the deselected editing area si-
multaneously. (*1)
When the machining programs in the 2nd part system exist, the message "Desig-
nated file already exists" appears and the file cannot be opened. (*1)
Operation
Operation
82