Mitsubishi Electric C80 Series Instruction Manual page 293

C80 Series Instruction Manual
8 Other Setups
Setting/output range of manual numerical value command
For each S, M, T, G and B command, the data type to output to PLC program is designated by parameters "#12006 Mbin
M binary", "#12008 Sbin S binary", "#12010 Tbin T binary" and "#12012 Bbin B binary". The output data type and the man-
ual numerical value command setting/output range are shown below:
Output S -99999999 to 99999999 (*1)
range
M
T
B
Setting S
range
M
T
B
(*1) Even if the parameter "#12008 Sbin" (S binary) is set to "0" (BCD), the signed binary output is applied to S. BCD output
is not applied.
(*2) If a negative value is set when the data type is "BCD type" or "No-signed binary type", a value converted into positive
value is output to PLC program.
Note
(1) Add a "-" sign before the value to set a negative value. The display will be a positive value.
(2) A value larger than "#3001 slimt1" to "#3004 slimt4" or "#3005 smax1" to "#3008 smax4" cannot be output for S. Select
a gear with "Spindle gear selection input" of Y device.
IB-1501453-C
BCD
0 to 99999999
-99999999 to 99999999 (*2)
No-signed binary
0 to 99999999
268
Signed binary
-99999999 to 99999999