Registering And Editing The Mdi Program - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables

3.3 Registering and Editing the MDI Program

Edit
Edit
Operation method for editing MDI program
(1) Press the menu [MDI] on the edit screen.
(2) Edit the MDI program.
Note
(1) Before starting MDI operation, confirm that the MDI settings are completed. If "Editing" or "MDI no setting" is displayed,
the MDI operation cannot be started.
When the [INPUT] key is pressed, the head block will be searched, and the message "MDI Set ended" will appear. The
setting will then be completed.
If the cursor is moved without editing, the block indicated by the cursor will be searched for when the [INPUT] key is
pressed.
(2) If the [INPUT] key is pressed when the number of MDI program characters including EOB (;) and EOR (%) exceeds
2000, "Memory capacity over" message will appear and the MDI program will not be searched for execution.
Note that the contents edited after the MDI program is saved last will not be saved in the NC.
(3) When the parameter "#1288 ext24/bit0" (MDI program clear) is set to "1", the MDI programs are cleared when MDI op-
eration ends, the power is turned ON again, reset is input and emergency stop is canceled, and only % programs are
saved.
When the parameter "#1285 ext21/bit0" (Multi-part system program management) is set to "1" (valid), the MDI program
of the part system in which MDI operation ends or the reset signal issues is cleared.
The MDI programs before editing is cleared during the MDI program editing.
Reset input refers to NC reset 1, NC reset 2 and reset & rewind.
MDI program clear is performed regardless of operation mode.
When MDI program is cleared during the character string replacement confirmation waiting or line clear confirmation
waiting, the character string replacement or line clear is canceled and each menu highlight returns to normal.
When MDI program is cleared after the range of the target block for line copy and line clear has been set, the desig-
nated machining program is de-highlighted.
IB-1501453-C
The menu is highlighted.
The MDI program is displayed from the head of the edit-
ing side.The cursor moves to the head character of the
program.
The cursor moves to the head character of the program.
The mode changes to the overwrite mode.
(When it is the initial insert mode, "INS" is displayed to
the right of the file name and the mode changes to the
insert mode.)
Refer to "3.6 Editing Operations".
58