C80 Series Instruction Manual
9 Machining a Workpiece
9.5 Correcting the Machining Program
Monitr
Edit
9.5.1 Program Editing
If you press the [Edit] main menu or set the edit/search signal ON, the program editing window appears to enable you to
edit a program. However, if the target program is not found (displays "O0"), the editing window does not appear. The pro-
gram is opened on the unselected side for the 2-part system simultaneous display.
When the program is edited, the key input data is directly written into the program display area. All data is overwritten from
the cursor position. "Editing" appears on the right side of the file name display once input is started.
When the [INPUT] key is pressed, the program is saved in the NC memory and the "Editing" message disappears.
A program to be edited can be switched to the other part system's program with
win $ switch" is set to "1".
For information on editing operations, refer to "3.2 Creating and Editing a Machining Program".
(3)
(4)
(5)
(6)
(1)
(2)
335
key when a parameter "#8952 Edit-
IB-1501453-C