Mitsubishi Electric C80 Series Instruction Manual page 111

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation method (Creating a new machining program (When the parameter "#1285 ext21/bit2" is set OFF and the 1st
part system is set as the displayed part system))
Perform the following procedure to create a new machining program, "600", under the following conditions.
The parameter "#8977 Multi-$ simul edit" is set to "1" (valid).
The parameter "#1285 ext21/bit2" is set to "0" (to collectively create new machining programs in all part systems).
(1) Press the menu [Open(New)].
(2) Input the machining program name (600) to be newly
created in the input section, then press the [INPUT]
key.
Operation to be performed when the menu [Open], [Open(New)], or [MDI] is pressed while editing a machining pro-
gram
If the menu [Open], [Open(New)], or [MDI] is pressed during editing of a machining program while the parameter "#8977
Multi-$ simul edit" is set to "1" (valid), whether to save both the contents of the currently selected editing area and those of
the deselected editing area is confirmed regardless of whether the machining program to be opened actually is targeted for
multi-part system simultaneous program editing.
Currently selected Deselected editing
editing area
Not editing Not editing
Editing Not editing
Not editing Editing
Editing Editing
IB-1501453-C
area
The operation of the pressed menu is performed.
(1) The operation message "Save current file? (Y/N)" is displayed.
(2) After any key has been pressed, the operation of the pressed menu is
performed.
(1) The message "Save right side file? (Y/N)" ("Save left side file? (Y/N)")
is displayed.
(2) After any key has been pressed, the operation of the pressed menu is
performed.
(1) The operation message "Save current file? (Y/N)" is displayed.
(2) After any key has been pressed, the operation message "Save right
side file? (Y/N)" ("Save left side file? (Y/N)") is displayed.
(3) After any key has been pressed, the operation of the pressed menu is
performed.
86
The list appears as a pop-up window.
The machining program "600" in the 1st part system is
displayed in the currently selected editing area, and the
machining program "600" in the 2nd part system is dis-
played in the deselected editing area.
Operation