Mitsubishi Electric C80 Series Instruction Manual page 173

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus
Menus
This executes an absolute input.
=Input
When "#8929 Disable=INPUT:comp" is set to "1", this menu cannot be selected.
This executes an incremental input.
+Input
This switches to the wear data display.
Wear
data
<Note>
This menu is displayed for type III only.
This switches to the tool length data display.
Length
data
<Note>
This menu is displayed for type III only.
This switches to the nose data display.
Nose
data
<Note>
This menu is displayed for type III only.
When the compensation No. is set and the [INPUT] key is pressed, the tool compensation data with that
Ofs No
number at its head appears.
search
The cursor moves to the contents of that first line.
Measure the tool compensation amount.
Measure
<Note>
This menu is displayed only for type III, and is valid for "L system" and "tool length data display".
This undoes the last changes to the tool compensation data.
Undo
(This menu is valid for the "Data Input", "Paste Line" and "Undo" operations.)
<Note>
When an operation parameter "#8939 Undo confirm msg" is set to "1", the menu is highlighted while
the operation message is displayed.
This copies the contents of the tool compensation data in the selected line (one line).
Line
copy
The contents (one line) of the copied tool compensation data are written to the line where the cursor is.
Line
If the copied data is changed after the menu [Line copy] is pressed, the data before changing is written
paste
when pasted.
The data in the copied line can be pasted as many times as is required until new data is copied.
This erases the compensation data in the selected line (multiple lines can be erased).
Line
Selection method: Select the first and the last compensation number to be erased.
clear
(Example) 1/E: Set all compensation data to "0".
If the [INPUT] key is pressed without selecting a line, the compensation data in the line where the cursor
is currently positioned is erased.
Switch the setting method (absolute/incremental input) for the tool compensation data by [INPUT] key.
Abs/Inc
<Note>
When a parameter "#8941 ABS/INC for T-ofs" is set to "0", it is fixed to an absolute input.
With type III, wear data is displayed when the power is turned ON.
After turning the power ON, the display selection for wear data, length data, and nose data will be retained.
IB-1501453-C
Details
148