Mitsubishi Electric C80 Series Instruction Manual page 329

C80 Series Instruction Manual
9 Machining a Workpiece
Display items
(2) Details of G modal
(3) Tool length and wear
compensation amount
display area
(4) Compensation num-
ber display area
IB-1501453-C
This item displays detailed information of the G command modal status of the currently
executed group.
Each item displays the following information.
G54.1:P10
The data format of the workpiece coordinate system offset number is as follows:
G5x :P
(x = 4 to 9)
G54.1: Pyy
(yy = 1 to 96)
When the high-speed machining mode, high-speed high-accuracy control, or direct
command mode specification is enabled, the status of the high-speed machining mode,
high-speed high-accuracy control, or direct command mode is displayed.
G05 :P0
G05 :P1
G05 :P2
G05.1: Q0
G05.1: Q1
G05 :P10000
G05 P4
Displays the current control mode.
When multiple control modes are enabled simultaneously, one of them is displayed in
the order in which the priority is higher.
(The priority is higher beginning at the top.)
VAC
CSC
SFR
SSS
When the high-accuracy control specification is enabled, the status of the high-accuracy
control mode is displayed.
G08:P0
G08:P1
Displays the currently selected machining condition parameter group.
* If the reference parameter is selected, "G120.1 P0" is displayed.
G120.1 P1 Q2
(Display example)
G120.1 P0
G120.1 P1 Q1 (*1)
This area displays the tool length and wear compensation amount.
TX: Displays the sum of the tool length and wear compensation amount of the first axis
for the tool in use. (*2)
TZ: Displays the sum of the tool length and wear compensation amount of the second
axis for the tool in use. (*2)
TY: Displays the sum of the tool length and wear compensation amount of the addi-
tional axis for the tool in use. (*3)
This area displays the compensation number.
TG: Displays the tool length compensation number.
TW: Displays the wear compensation number.
304
Details
Workpiece coordinate system offset No.
G54 Workpiece coordinate system selection 1
G55 Workpiece coordinate system selection 2
G56 Workpiece coordinate system selection 3
G57 Workpiece coordinate system selection 4
G58 Workpiece coordinate system selection 5
G59 Workpiece coordinate system selection 6
G54.1 Workpiece coordinate system selection
The number of extension sets is assigned to 0, 48, or 96
sets depending on the additional specifications.
OFF
High-speed machining mode I ON
High-speed machining mode II ON
High-speed high-accuracy control I OFF
High-speed high-accuracy control I ON
High-speed high-accuracy control II ON
Direct command mode ON
Variable-acceleration pre-interpolation acceleration/de-
celeration enabled
Corner smooth control enabled
Smooth fairing ON
SSS enabled
High-accuracy control mode OFF
High-accuracy control mode ON
Machining Condition Selection I
Reference parameter selected
Each machining condition parameter selected
Pn: (n=1 to 3) Machining purpose
Qm: (m=1 to 3) Condition