Mitsubishi Electric C80 Series Instruction Manual page 65

C80 Series Instruction Manual
2 Screen Operations
Display items
(16) CLOSE key
(17) Key display switch key This switches numerical keypad display/all keys display.
(*1) For details on the behavior of this button, refer to the device No. X2F0 (signal name: BOARD RESET, signal abbrevi-
ation: BRST) in "M800/M80/C80 Series PLC Interface Manual".
Input area of software keyboard
If the software keyboard is displayed while the input area exists on the screen, the input area of the software keyboard is
displayed in the enable state. When the data setting key or data correction key is selected while the input area is enabled,
enter a key in the input area of the software keyboard, and use the [INPUT] key to enter data in the screen.
Furthermore, if the software keyboard is displayed to edit a program file when the input area does not exist on the screen
or while the editing window or MDI editing window is being displayed, the input area of the software keyboard is displayed
into the disable state. In this case, directly enter a key in the screen.
When you enter a key to type the password, an asterisk "*" appears in the input area of the software keyboard.
Displaying/closing the software keyboard
Touching the [S/W Key] button on the lower left of the screen allows you to display the software keyboard on the screen.
(1) Touch the [S/W Key] button.
(2) Touch the [CLOSE] key.
Or, touch the [S/W Key] button again.
Switching the view mode (all keys display/numerical keypad display)
Touching the [ALLKEY] key on the software keyboard allows you to switch the software keyboard view mode between "nu-
meric keypad view" and "all key view". "Numeric keypad view" is specified by default.
(1) Touch the [S/W Key] button.
(2) Touch the [ALLKEY] key at the bottom of the soft-
ware keyboard.
(3) Touch the [ALLKEY] key at the bottom of the soft-
ware keyboard.
IB-1501453-C
This closes the software keyboard.
40
Details
The software keyboard is displayed on the front screen.
The [S/W Key] button is highlighted.
The software keyboard will close.
The software keyboard is displayed on the left side of the
screen.
The software keyboard is displayed as a numerical key-
pad.
All keys, including alphabet character keys, are dis-
played.
The [ALLKEY] key is highlighted.
The display is switched to the numerical keypad only.
The [ALLKEY] key is unhighlighted.