Mitsubishi Electric C80 Series Instruction Manual page 253

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
<Setup screen>
(1)
(2)
(5)
Display items
Display items
(1) Tool L offset num
(2) Wear offset num
(3) On mea
(4) Guide graphic
(5) Work shift value
(6) Meas posn
(7) Input section
(*1) If an illegal value is set, the value is blank ("0" is displayed).
(*2) The No. is displayed by BCD code.
(*3) If an illegal value is set or tool nose wear data is not used for measurement (parameter "#1226 aux10/bit0" is "1"), the
value is blank ("0" is displayed).
(*4) When the workpiece coordinate offset measurement specification is invalid, the value is not displayed during measure-
ment even if the measurement switch is set ON.
(*5) To display the 9th axis and after, use the menu [Next axis].
IB-1501453-C
This displays the compensation No. of the tool length data used in the automatic set-
ting. (*1) (*2)
This displays the compensation No. of the tool nose wear data used in the automatic
setting. (*2) (*3)
When the measurement switch is ON and the operation mode is manual mode (han-
dle, jog, rapid traverse, or step), "On mea" is displayed, and the workpiece can be
measured by the workpiece coordinate system shift write mode signal. (*4)
This displays the measurement area.
This displays the currently designated workpiece coordinate system shift value. (*5)
The initial cursor position is located at the 1st axis in all part systems.
If the cursor position is changed using cursor movement keys or the menu [Next axis],
it is held until the program is placed into the following status.
Monitor screen: The cursor position is not held.
Setup screen: The cursor position is held until the power is turned on again.
The measurement position (machine position - tool length compensation amount of
the T-commanded tool) is displayed. (*5)
This displays the input data.
228
Details
(3)
(4)
(6)
(7)