Mitsubishi Electric C80 Series Instruction Manual page 324

C80 Series Instruction Manual
9 Machining a Workpiece
Menus
This displays the position of the tool center from the machine coordinate system reference position in
Tip
the machine coordinate system.
machine
This displays the amount moved in the selected axis direction using the manual pulse generator in the
Pulse
hypothetical machine coordinate system.
Basically this is updated only when manual ABS is OFF. If "#7905 NO_ABS" is set to "1", this will be
updated regardless of the manual ABS ON/OFF.
This displays the table coordinate.
Table co
posn
This displays the inclined surface coordinate.
Incline
co posn
This switches the axis to be displayed on the counter. This switches the axes to be displayed on the
Next
counter between "1st axis to 12th axis" and "13th axis or after".
axis
Note
(1) The type of counter displayed first when the pop-up display appears is the relative position.
However, when any of the targeted specifications (*1) is valid, "Tip workpiece position" is displayed. The counter which
appears next is the type selected previously.
(2) The menus [Tip wk posn], [Tip machine], [Pulse] and [Table co posn] appear when any of the targeted specifications
(*1) is valid.
(3) The menu [Incline co posn] is displayed when the additional specification of the inclined surface machining command
is valid.
(*1) Targeted specifications
Tool center point control
Tool length compensation along the tool axis
Tool handle feed & interruption
Inclined surface machining command
3-dimensional tool radius compensation (tool's vertical-direction compensation)
3-dimensional manual feed
Details
299 IB-1501453-C