Mitsubishi Electric C80 Series Instruction Manual page 78

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Menus
Menus
This edits and references the existing programs.
Open
When the program number is designated and the [INPUT] key is pressed, the program contents appear
and can be edited.
This creates a new program.
Open
When the program number is set and the [INPUT] key is pressed, new comment or program contents
(New)
can be created.
This edits the MDI program.
MDI
When this menu key is pressed, the MDI program appears and can be edited.
When the line number is set and the [INPUT] key is pressed, the program data for the set number and
Line
later is displayed on the screen. The cursor moves to the set line number.
jump
The area that can be edited is switched between the left and right areas.
<-->
change
This menu can be selected for the multi-program display type.
The display type (multi-program display, G code guidance display, and playback display) is switched.
Display
change
A blank line is inserted so that the timing synchronization symbols (the timing synchronization opera-
Synchro
tions of the machining program) are aligned horizontally.
view
<Note>
This menu is grayed out and non-selectable in the following cases.
- When the parameter "#1285 ext21/bit0" (Multi-part system program management) is set to "0" (in-
valid).
- When the program numbers displayed in the left and right editing areas are different.
An operation search is carried out for the currently opened program with the block located by the cursor
Cursor
at the top.
OP srch
When the operation search is completed, the display switches to the monitor screen.
<Note>
If the parameter "#1285 ext21/bit0" (Multi-part system program management) is set to "1" (valid),
or the program is being edited, this menu is grayed out and non-selectable.
When the character string is designated and the [INPUT] key is pressed, that character string is
String
searched for.
search
If the character string to be searched for and the character string to be replaced are separated with a
String
"/" and designated, when the [INPUT] key is pressed, the character string is replaced.
replace
This copies the designated line (multiple lines can be copied.)
Line
copy
The character string (multiple lines acceptable) designated by the cursor is copied.
Char
copy
This inserts the most recently copied contents to the line before the cursor or the position before the
Paste
cursor.
This erases the designated line (multiple lines can be erased).
Line
clear
This returns the contents of the program to that prior to saving and display.
Undo
This menu cannot be selected when parameter "#8910 Edit undo" is set to "0".
<Note>
When the parameter "#8939 Undo confirm msg" is set to "1", the menu is highlighted while the op-
eration message is displayed.
The sequence No. can be added automatically by pressing the [INPUT] key after designating an ad-
N auto
ditional value.
add
This registers the MDI program in the memory.
MDI
This can be performed only when the MDI program is displayed.
regist
Details
53 IB-1501453-C