Mitsubishi Electric C80 Series Instruction Manual page 12

9. Other items
MITSUBISHI CNC C80, which is an open equipment, must be installed within a sealed metal control panel (IP54 or
higher). C80 must also be used and stored under the conditions listed in the table of specifications below.
Ambient tempera-
ture
Ambient Humidity During operation
Vibration resis-
tance
Shock resistance
Operating atmosphere
Altitude
Installation location
Overvoltage category (*1)
Pollution level (*2)
(*1) This indicates the section of the power supply to which the equipment is assumed to be connected between the public
electrical power distribution network and the machinery within premises.
Category II applies to equipment for which electrical power is supplied from fixed facilities.
The surge withstand voltage for the equipment up to the rated 300V is 2500V.
(*2) This index indicates the degree to which conductive material is generated in terms of the environment in which the
equipment is used.
Pollution level 2 is when only non-conductive pollution occurs; however, a temporary conductivity caused by condensing
must be expected occasionally.
(*3) Do not use or store C80 under pressure higher than the atmospheric pressure of altitude 0m. Doing so can cause an
operation failure.
Note
(1) The following environment conditions are required for the layout design.
No large amount of conductible dust, iron filings, oil mist, salt, or organic solvents
No direct sunlight
No strong electrical or magnetic fields
No direct vibrations nor shocks on C80
Item
During operation
During storage
During storage
Compliant
Under intermit-
with JIS B
tent vibration
3502 and IEC
61131-2
Under continuous
vibration
CAUTION
5 to 95%RH, non-condensing
5 to 95%RH, non-condensing
Frequency Constant accel-
eration
5 to 8.4Hz -
8.4 to 150Hz
9.8m/s
5 to 8.4Hz -
8.4 to 150Hz
4.9m/s
2
147m/s , 3 times in each of 3 directions X, Y, Z
No corrosive gases nor inflammable gases
2000m or less (*3)
Inside control panel
Specification
0 to 55 °C
-25 to 75 °C
Half amplitude
3.5mm 10 times each in X,
Y, Z directions (For
2 -
1.75mm
-
2
II or less
2 or less
Sweep count
80 min.)