Mitsubishi Electric C80 Series Instruction Manual page 57

C80 Series Instruction Manual
2 Screen Operations
G codes displayed in the G code guidance area
With G code guidance function, the commands having "G" followed by 1 or more numbers are regarded as the G code.
Thus, when "G" that is located immediately before the cursor is within the comment, the guidance will not be refreshed. In
the same manner, when a G code is commanded using variables such as "G#100" or "G#500", etc. but numbers, the guid-
ance will not be refreshed.
The G code that can be displayed in the guidance area is as follows.
Gnnnnnnnn.m L ll ("n", "m", and "l" are arbitrary number.)
Commanded value Number of valid digits
n (integer) 1 to 8 digit
m (decimal places) 0 to 1 digit
l (value commanded 0 to 2 digit
using "L")
Note
(1) As for the G codes not included in the specifications, the guidance is not displayed even if the above condition is met.
G00 X100. (GCODE)
N11 GOTO1 2 ;
G91 G120 X100. Y100. ;
G00000031.1 ;
G00000031.10 ;
L50 G10 ;
IB-1501453-C
When including "0" before integer command value, unnecessary "0" is
ignored.
-
This is valid when "L" exists immediately after the integer command
value or decimal command value and is followed by a command value.
If the command with "L" address precedes G code, the "L" command
will not be described in the guidance.
"G" included in the comment "GCODE" is ignored, thus, G code guidance is
;
not refreshed.
"G" included in the command "GOTO" is ignored, thus, G code guidance is not
refreshed.
G code "G120" is not included in the specifications, thus, G code guidance is
not refreshed.
The guidance for G31.1 is displayed.
Commanded value exceeds the number of valid digits, thus, G code guidance
is not refreshed.
The guidance not for "G10 L50" but "G10" is displayed.
Remarks
32