Mitsubishi Electric C80 Series Instruction Manual page 401

C80 Series Instruction Manual
10 Troubleshooting
Display items
(4) 1-shot output
Menus
Menus
This changes the setting area to an input standby status. The signal is forcibly output (modal).
Modal
output
This changes the setting area to an input standby status. The signal is forcibly output (one-shot).
1-shot
output
A confirmation message appears, and the machine turns into standby status. The force OP (one-shot
Modal
output) of all I/O signals are canceled. (*1)
all clr
(*1) These menus are grayed out ordinarily, and cannot be operated.
How to read the device No. and display data
A device is an address for classifying a signal handled in the PLC. A device No. is a series of numbers attached to that
device.
Device No. (bit-type)
7 6 5
X0008 1 0 1
XF XE XD XC XB XA X9 X8
X0010 0 1 1
X17 X16 X15 X14 X13 X12 X11 X10
X0018 0 0 0
X1F X1E X1D X1C X1B X1A X19 X18
Device No. (word-type)
7 6 5
1 0 1
R0010
0 1 1
IB-1501453-C
This displays the data and device to carry out one-shot output.
The details to be defined are set here when carrying out the one-shot type forced out-
put of PLC interface signals.
For details, refer to "Carrying Out One-shot Output".
4 3 2 1 0
0 0 0 0 1
0 1 0 1 0
0 1 0 0 0
4 3 2 1 0
High-order
0 0 0 0 1
8 bits
Low-order
0 1 0 1 0
8 bits
Details
Details
Signal status display
corresponding to each
device No. (I/O)
376