Mitsubishi Electric C80 Series Instruction Manual page 169

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
[Tool compensation type III] (L System): Parameter "#1037 cmdtyp" = 3
This type has 3 kinds of display such as wear data, tool length data, and nose data. The display can be switched by the
sub menu.
Wear data
Set the wear amount of nose for each tool you use.
When a tool compensation number is designated by the tool command (T command), the wear data is offset together
with the tool length data and nose data.
Tool length data
Set the tool length according to the reference position of program for each tool used.
When a tool compensation number is designated by the tool command (T command), the tool length data is offset
together with the wear data and nose data.
IB-1501453-C 144
(1)
(1)