Mitsubishi Electric C80 Series Instruction Manual page 322

C80 Series Instruction Manual
9 Machining a Workpiece
Changing MSTB display
On the monitor screen in 2-part system simultaneous view, you can press the [MST Chg] main menu to change the MSTB
display for the area to be operated.
The MSTB display type is held for each part system when the screen is switched or the power is turned ON again.
<2-part system simultaneous view: Counter1 (expand) / Quad counter>
There are the following two types of MSTB displays, which are toggled each time the menu [MST Chg] is pressed.
MSTB display type (*1) (*2) (*3)
MSTB + Workpiece machining count display type (*1) (*2)
(*1) The S command is used to designate the spindle to be displayed for each part system using parameters (#8925 to
#8928 ("SP on 1st part sys" to "SP on 4th part sys") and #8958 to #8960 ("SP on 5th part sys" to "SP on 7th part sys")).
Up to two spindles can be designated in each part system. The M (miscellaneous function command value), T (tool
command value), and B (2nd miscellaneous function command value) functions are displayed one by one regardless
of the value of the parameter "#12005 Mfig" (M count), "#12009 Tfig" (T count), or "#12011 Bfig" (B count). However,
the B (2nd miscellaneous function command value) function is displayed or hidden depending on the value of the pa-
rameter "#1170 M2name" (2nd miscellaneous code).
(*2) The menu [MST Chg] is not available in the following cases:
The parameter "#8001 WRK COUNT M" is set to "0".
"F" is set to the low-order byte of parameters #8925 to #8928 ("SP on 1st part sys" to "SP on 4th part sys") and #8958
to #8960 ("SP on 5th part sys" to "SP on 7th part sys"), or the parameter "#1039 spinno" is set to "1".
(*3) When the number of spindles is set to "1" or only one spindle is displayed depending on the operation parameters
(#8925 to #8928 ("SP on 1st part sys" to "SP on 4th part sys") and #8958 to #8960 ("SP on 5th part sys" to "SP on 7th
part sys"), the load meter of the target spindle is displayed at the position at which the second spindle is to be displayed.
<2-part system simultaneous view: Dual counter>
There are the following six types of MSTB displays, which are toggled each time the menu [MST Chg] is pressed.
MSTB display type (*1)
S display type 1
S display type 2
MTB display type
MTB + Workpiece machining count display type
MSTB + Workpiece machining count display type (*1)
(*1) When the number of spindles is set to "1" or only one spindle is displayed depending on the operation parameters
(#8925 to #8928 ("SP on 1st part sys" to "SP on 4th part sys") and #8958 to #8960 ("SP on 5th part sys" to "SP on 7th
part sys"), the load meter of the target spindle is displayed at the position at which the second spindle is to be displayed.
Customizing the screen display (Select display area (parameter "#8973 Selective display" = "1"))
A part of the monitor screen (normal view) can be customized to suit user's need (to display data which a user always needs
to refer to). The select display area shows the screen that is selected using the parameter "#8940 Set select display".
297 IB-1501453-C