C80 Series Instruction Manual
9 Machining a Workpiece
Display items
(7)
Speed display
(8)
Cycle time display
(9)
Control mode dis-
play
(10) G modal simple dis-
play
(11) M and B commands This area displays the command value for each of the M (miscellaneous function command
(12) M, S, T, and B com-
mands
(2-part system simul-
taneous display)
(13) Spindle rotation
speed display
(2-part system simul-
taneous display)
(14) Workpiece machin-
ing count display
Interpolation feeding: Displays the vector-direction speed (FA), dwell time, etc. of the axis
currently being moved.
Each axis independent feeding: Displays the speed of the axis with the highest speed des-
ignated.
In the L system, the surface speed is displayed.
When the parameter "#1125 real_f" is set to "1", the actual machine feedrate is displayed.
This area displays the automatic operation time and cycle time.
The display item can be switched in the integrated time window.
DAT: Date
TIM: Time
PON: Power ON
OP: Automatic operation
STL: Automatic start
EX1: Ext time1
EX2: Ext time2
CYC: Cycle time
This area displays the NC control mode.
HTP: High-speed synchronous tapping
MOR: Manual arbitrary reverse run mode
SSS: SSS control
CSC: Corner smooth control
VAC: Variable-acceleration pre-interpolation acceleration/deceleration
EAC: Allowable acceleration for each axis (*3)
SFR: Smooth fairing
FRG: Fairing
Up to six control modes are displayed beginning at the top.
This area displays the following modal status.
G command modal status of G code group 1
G command modal status of G code group 3
Currently selected workpiece coordinate system offset
Tool radius compensation modal, compensation number, tool shape amount, and tool ra-
dius wear
Tool length compensation modal, compensation axis name, compensation number, tool
shape amount, and tool length wear
value) and B (2nd miscellaneous function command value) functions.
<In 1-part system display>
The M (miscellaneous function command value) and B (2nd miscellaneous function com-
mand value) displays vary depending on the values of the parameters "#12005 Mfig" and
"#1170 M2name".
Using the menu [MST Chg] allows you to switch the MSTB display in the area to be operat-
ed. (For details, refer to "Changing MSTB display" in "9.2.5 Operation of 2-part System Si-
multaneous Display".)
This area displays the spindle rotation speed and the spindle command value that are des-
ignated in the parameters "#8925 to #8928" ("SP on 1st part sys" to "SP on 4th part sys")
and "#8958 to 8960" ("SP on 5th part sys" to "SP on 7th part sys").
This area displays the current number of workpiece machining.
The display varies depending on the setting of the parameter #8001 to #8003.
However, when the parameter "#8001 WRK COUNT M" is set to "0", the number of work-
piece machining is not counted, and it is not displayed on the screen.
The setting value of the parameter "#8001 WRK COUNT M" is displayed up to high-order
two digits.
Details
289
IB-1501453-C