Pressure Plate; Removaulnspection - Honda Prelude 1993 Service Manual

Pressure Plate
I
RemovaUlnspection
ALIGNMENT
Dtsc
OTJAF -
PM7O11A
07936 - 3710100
4. Install the special tools as shown.
Inspect the fingers of the diaphragm spring for wear
at the release bearing contact area.
Assemble the specialtools as shown.
N O T E : A s s e m b l e t h e C l u t c h A l i g n m e n t D i s c w i t h
side "A" facing the diaphragm spring as shown.
Check the diaphragm spring fingers for height usrrg
the specialtools and a feeler gauge.
Standard (New): 0.6 mm {0.02 in) max.
Service Limit:
0,8 mm {0.03 in)
CLUTCH
RING GEAR HOLDER
ADJUSTER NUT
AOJUSTEB BOLT
FEELER GAUGE
CLUTCH ALIGNMENT SHAFT
07LAF - PTOo110
I
45 N.m
(4.5 kg-m,
33 tb-ft)
RING GEAR HOLDER
07LAB - PV001 00
07924 - PD20003
HANDLE
07936 - 3710100
SHAFT
07LAF - PT00110
* /
/ '
I A L I G N M E N T
ENGINE BLOCK
HANDLE
CLUTCH
WASHER
12-8
BOLT
PRESSURE PLATE
To prevent warping. unscrew the pressure plate
mounting bolts in a crisscross pattern in several
steps. then remove the pressure plate.
Inspect the pressure plate surface for wear, cracks,
a n d b u r n i n g .
Inspect for warpage using a straight edge and a
feeler gauge.
NOTE: Measure across the pressure plate at three
pornts.
Standard (lrl6wl: 0.03 mm (O.0Ol in) max.
Sorvicc Limit
0.15 mm (0.006 in)
1 .
STRAIGHT EDGE
FEELER GAUGE