Cisco 28/37/38Xx Integrated Services Router - Cisco 2100 Series Configuration Manual

Appendix E Logical Connectivity Diagrams
The commands used for communication between the Cisco WiSM, the Supervisor 720, and the 4404
controllers are documented in Configuring a Cisco Wireless Services Module and Wireless Control
System at this URL:
http://www.cisco.com/en/US/docs/wireless/technology/wism/technical/reference/appnote.html#wp394
98

Cisco 28/37/38xx Integrated Services Router

Figure E-2
28/37/38xx
Integrated
Services Router
Controller
Network Module
These commands are used for communication between the 28/37/38xx Integrated Services Router and
the controller network module. They are initiated from the router. The commands vary depending on the
version of the network module.
These commands are used for communication between the router and Fast Ethernet versions of the
controller network module:
•
•
•
•
•
•
These commands are used for communication between the router and Gigabit Ethernet versions of the
controller network module:
•
•
•
•
OL-17037-01
Logical Connectivity Diagram for the Cisco 28/37/38xx Integrated Services Router
Console
Router CPU
(Cisco IOS Software)
Internal Ethernet
Interface
Internal Ethernet
Interface 1
Compact Flash
interface wlan-controller slot/unit (and support for subinterfaces with dot1q encap)
show interfaces wlan-controller slot/unit
show controllers wlan-controller slot/unit
test service-module wlan-controller slot/unit
test HW-module wlan-controller slot/unit reset {enable | disable}
service-module wlan-controller slot/port {reload | reset | session [clear] | shutdown | status}
interface integrated-service-engine slot/unit (and support for subinterfaces with dot1q encap)
show interfaces integrated-service-engine slot/unit
show controllers integrated-service-engine slot/unit
test service-module integrated-service-engine slot/unit
Cisco 28/37/38xx Integrated Services Router
Memory
Flash
CPU
Memory
Cisco Wireless LAN Controller Configuration Guide
StrataFlash
E-3