Using The Cli To Configure The Ap-Manager Interface; Using The Cli To Configure The Virtual Interface - Cisco 2100 Series Configuration Manual

Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces

Using the CLI to Configure the AP-Manager Interface

Follow these steps to display and configure the AP-manager interface parameters using the CLI.
Step 1 Enter show interface summary to view the current interfaces.
Note
Enter show interface detailed ap-manager to view the current AP-manager interface settings.
Step 2
Enter config wlan disable wlan-number to disable each WLAN that uses the AP-manager interface for
Step 3
distribution system communication.
Enter these commands to define the AP-manager interface:
Step 4
•
•
•
•
•
Enter save config to save your changes.
Step 5
Enter show interface detailed ap-manager to verify that your changes have been saved.
Step 6

Using the CLI to Configure the Virtual Interface

Follow these steps to display and configure the virtual interface parameters using the CLI.
Step 1 Enter show interface detailed virtual to view the current virtual interface settings.
Enter config wlan disable wlan-number to disable each WLAN that uses the virtual interface for
Step 2
distribution system communication.
Cisco Wireless LAN Controller Configuration Guide
3-14
If the system is operating in Layer 2 mode, the AP-manager interface is not listed.
config interface address ap-manager ip-addr ip-netmask gateway
config interface vlan ap-manager {vlan-id | 0}
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
Note
using tagged VLANs for the AP-manager interface.
config interface port ap-manager physical-ds-port-number
config interface dhcp ap-manager ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl ap-manager access-control-list-name
See Chapter 5 for more information on ACLs.
Note
Chapter 3 Configuring Ports and Interfaces
OL-17037-01