Cisco 2100 Series Configuration Manual page 95

Chapter 3 Configuring Ports and Interfaces
Figure 3-18
Enter the appropriate interface parameters.
Step 5
Note
To make the interface an AP-manager interface, check the Enable Dynamic AP Management check
Step 6
box.
Click Save Configuration to save your settings.
Step 7
Repeat this procedure for each additional AP-manager interface that you want to create.
Step 8
OL-17037-01
Interfaces > Edit Page
Do not define a backup port for an AP-manager interface. Port redundancy is not supported for
AP-manager interfaces. If the AP-manager interface fails, all of the access points connected to
the controller through that interface are evenly distributed among the other configured
AP-manager interfaces.
Configuring a 4400 Series Controller to Support More Than 48 Access Points
Cisco Wireless LAN Controller Configuration Guide
3-39