Using The Cli To Configure The Management, Ap-Manager, Virtual, And Service-Port Interfaces; Using The Cli To Configure The Management Interface - Cisco 2100 Series Configuration Manual

Chapter 3 Configuring Ports and Interfaces
Using the CLI to Configure the Management, AP-Manager, Virtual, and
Service-Port Interfaces
This section provides instructions for displaying and configuring the management, AP-manager, virtual,
and service-port interfaces using the CLI.

Using the CLI to Configure the Management Interface

Follow these steps to display and configure the management interface parameters using the CLI.
Enter show interface detailed management to view the current management interface settings.
Step 1
Note
Step 2 Enter config wlan disable wlan-number to disable each WLAN that uses the management interface for
distribution system communication.
Enter these commands to define the management interface:
Step 3
•
•
•
•
•
•
Enter save config to save your changes.
Step 4
Enter show interface detailed management to verify that your changes have been saved.
Step 5
OL-17037-01
The management interface uses the controller's factory-set distribution system MAC address.
config interface address management ip-addr ip-netmask gateway
config interface quarantine vlan management vlan_id
Note Use this command to configure a quarantine VLAN on the management interface.
config interface vlan management {vlan-id | 0}
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
Note
using tagged VLANs for the management interface.
config interface port management physical-ds-port-number
config interface dhcp management ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl management access-control-list-name
See Chapter 5 for more information on ACLs.
Note
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Cisco Wireless LAN Controller Configuration Guide
3-13