Safety Considerations; Warning Definition - Cisco 2100 Series Configuration Manual

Safety Considerations

Safety Considerations
Keep these guidelines in mind when installing Cisco UWN Solution products:
•
•
•
•
•
•
•

Warning Definition

IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device. Statement 1071
SAVE THESE INSTRUCTIONS
Waarschuwing BELANGRIJKE VEILIGHEIDSINSTRUCTIES
Dit waarschuwingssymbool betekent gevaar. U verkeert in een situatie die lichamelijk letsel kan
veroorzaken. Voordat u aan enige apparatuur gaat werken, dient u zich bewust te zijn van de bij
elektrische schakelingen betrokken risico's en dient u op de hoogte te zijn van de standaard
praktijken om ongelukken te voorkomen. Gebruik het nummer van de verklaring onderaan de
waarschuwing als u een vertaling van de waarschuwing die bij het apparaat wordt geleverd, wilt
raadplegen.
BEWAAR DEZE INSTRUCTIES
Cisco Wireless LAN Controller Configuration Guide
A-2
The Cisco lightweight access points with or without external antenna ports are only intended for
installation in Environment A as defined in IEEE 802.3af. All interconnected equipment must be
contained within the same building including the interconnected equipment's associated LAN
connections.
For lightweight access points provided with optional external antenna ports, make sure that all
external antennas and their associated wiring are located entirely indoors. These lightweight access
points and their optional external antennas are not suitable for outdoor use.
Make sure that plenum-mounted lightweight access points are powered using Power over Ethernet
(PoE) to comply with safety regulations.
For all controllers, verify that the ambient temperature remains between 0 and 40° C (32 and 104°
F), taking into account the elevated temperatures that occur when they are installed in a rack.
When multiple controllers are mounted in an equipment rack, be sure that the power source is
sufficiently rated to safely run all of the equipment in the rack.
Verify the integrity of the ground before installing controllers in an equipment rack.
Lightweight access points are suitable for use in environmental air space in accordance with Section
300.22.C of the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian
Electrical Code, Part 1, C22.1.
Appendix A Safety Considerations and Translated Safety Warnings
OL-17037-01