Using The Gui To Configure Mfp - Cisco 2100 Series Configuration Manual

Configuring Management Frame Protection

Using the GUI to Configure MFP

Follow these steps to configure MFP using the controller GUI.
Click Security > Wireless Protection Policies > AP Authentication/MFP. The AP Authentication
Step 1
Policy page appears (see
Figure 5-37
Step 2 To enable infrastructure MFP globally for the controller, choose Management Frame Protection from
the Protection Type drop-down box.
Click Apply to commit your changes.
Step 3
Note
Follow these steps if you want to disable or re-enable infrastructure MFP for a particular WLAN after
Step 4
MFP has been enabled globally for the controller:
a.
b.
c.
Cisco Wireless LAN Controller Configuration Guide
5-68
Figure
AP Authentication Policy Page
If more than one controller is included in the mobility group, you must configure a Network
Time Protocol (NTP) server on all controllers in the mobility group that are configured for
infrastructure MFP.
Click WLANs.
Click the profile name of the desired WLAN. The WLANs > Edit page appears.
Click Advanced. The WLANs > Edit (Advanced) page appears (see
5-37).
Chapter 5 Configuring Security Solutions
Figure 5-38).
OL-17037-01