Configuring Dynamic Interfaces
Configuring Dynamic Interfaces
This section provides instructions for configuring dynamic interfaces using either the GUI or CLI.
Using the GUI to Configure Dynamic Interfaces
Follow these steps to create new or edit existing dynamic interfaces using the GUI.
Step 1
Click Controller > Interfaces to open the Interfaces page (see
Step 2
Perform one of the following:
•
•
•
Figure 3-6
Step 3
Enter an interface name and a VLAN identifier, as shown in
Click Apply to commit your changes. The Interfaces > Edit page appears (see
Step 4
Cisco Wireless LAN Controller Configuration Guide
3-16
To create a new dynamic interface, click New. The Interfaces > New page appears (see
Go to
Step
3.
To modify the settings of an existing dynamic interface, click the name of the interface. The
Interfaces > Edit page for that interface appears (see
To delete an existing dynamic interface, hover your cursor over the blue drop-down arrow for the
desired interface and choose Remove.
Interfaces > New Page
Chapter 3
Configuring Ports and Interfaces
Figure
3-5).
Figure
3-7). Go to
Step
5.
Figure
3-6.
Figure
Figure
3-6).
3-7).
OL-17037-01