Using The Cli To View System And Message Logs - Cisco 2100 Series Configuration Manual

Configuring System and Message Logging
To save debug messages to the controller buffer, the controller console, or a syslog server, enter these
Step 5
commands:
•
•
•
By default, the console command is enabled, and the buffered and syslog commands are disabled.
To cause the controller to include information about the source file in the message logs or to prevent the
Step 6
controller from displaying this information, enter this command:
config logging fileinfo {enable | disable}
The default value is enabled.
To cause the controller to include process information in the message logs or to prevent the controller
Step 7
from displaying this information, enter this command:
config logging procinfo {enable | disable}
The default value is disabled.
To cause the controller to include traceback information in the message logs or to prevent the controller
Step 8
from displaying this information, enter this command:
config logging traceinfo {enable | disable}
The default value is disabled.
To enable or disable timestamps in log messages and debug messages, enter these commands:
Step 9
•
•
Step 10 To save your changes, enter this command:
save config

Using the CLI to View System and Message Logs

To see the logging parameters and buffer contents, enter this command:
show logging
Information similar to the following appears:
Logging to buffer :
- Logging of system messages to buffer :
- Logging filter level.......................... errors
- Number of system messages logged.............. 8716
- Number of system messages dropped............. 2906
- Logging of debug messages to buffer ........... Disabled
- Number of debug messages logged............... 0
- Number of debug messages dropped.............. 0
Cisco Wireless LAN Controller Configuration Guide
D-12
config logging debug buffered {enable | disable}
config logging debug console {enable | disable}
config logging debug syslog {enable | disable}
config service timestamps log {datetime | disable}
config service timestamps debug {datetime | disable}
where
datetime = Messages are timestamped with the standard date and time. This is the default value.
–
disable = Messages are not timestamped.
–
Appendix D Troubleshooting
OL-17037-01