Cisco 2100 Series Configuration Manual page 563

Chapter 10 Managing User Accounts
Figure 10-18
From the Type drop-down box, choose Guest LAN.
Step 12
In the Profile Name field, enter a name that identifies the guest LAN. Do not use any spaces.
Step 13
In the WLAN SSID field, enter an SSID that identifies the guest LAN. Do not use any spaces.
Step 14
From the WLAN ID drop-down box, choose the ID number for this guest LAN.
Step 15
Note
Click Apply to commit your changes. The WLANs > Edit page appears (see
Step 16
Figure 10-19
Check the Enabled check box for the Status parameter.
Step 17
Step 18 Web authentication (Web-Auth) is the default security policy. If you want to change this to web
passthrough, click the Security tab after completing
From the Ingress Interface drop-down box, choose the VLAN that you created in
Step 19
provides a path between the wired guest client and the controller by way of the Layer 2 access switch.
From the Egress Interface drop-down box, choose the name of the interface. This WLAN provides a path
Step 20
out of the controller for wired guest client traffic.
Note
If you want to change the authentication method (for example, from web authentication to web
Step 21
passthrough), click Security > Layer 3. The WLANs > Edit (Security > Layer 3) page appears (see
Figure
OL-17037-01
WLANs > New Page
You can create up to five guest LANs, so the WLAN ID options are 1 through 5 (inclusive).
WLANs > Edit Page
If you have only one controller in the configuration, choose management from the Egress
Interface drop-down box.
10-20).
Configuring Wired Guest Access
Step 19 and Step 20.
Cisco Wireless LAN Controller Configuration Guide
Figure 10-19).
Step 3. This VLAN
10-27