Using The Cli To Configure Dhcp Proxy; Configuring Administrator Usernames And Passwords; Configuring Usernames And Passwords - Cisco 2100 Series Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
To enable DHCP proxy on a global basis, check the Enable DHCP Proxy check box. Otherwise,
Step 2
uncheck the check box. The default value is checked.
Step 3 Click Apply to commit your changes.
Click Save Configuration to save your changes.
Step 4

Using the CLI to Configure DHCP Proxy

Using the controller CLI, follow these steps to configure DHCP proxy.
To enable or disable DHCP proxy, enter this command:
Step 1
config dhcp proxy {enable | disable}
Step 2 To view the DHCP proxy configuration, enter this command:
show dhcp proxy
Information similar to the following appears:
DHCP Proxy Behavior: enabled

Configuring Administrator Usernames and Passwords

You can configure administrator usernames and passwords to prevent unauthorized users from
reconfiguring the controller and viewing configuration information. This section provides instructions
for initial configuration and for password recovery.

Configuring Usernames and Passwords

Using the controller CLI, follow these steps to configure administrator usernames and passwords:
To configure a username and password, enter one of these commands:
Step 1
•
•
Usernames and passwords are case-sensitive and can contain up to 24 ASCII characters. Usernames and
passwords cannot contain spaces.
Note
OL-17037-01
config mgmtuser add username password read-write—Creates a username-password pair with
read-write privileges.
config mgmtuser add username password read-only—Creates a username-password pair with
read-only privileges.
If you ever need to change the password for an existing username, enter this command:
config mgmtuser password username new_password
Configuring Administrator Usernames and Passwords
Cisco Wireless LAN Controller Configuration Guide
4-23