Cisco 2100 Series Configuration Manual page 464

Adding Mesh Access Points to the Mesh Network
Using the GUI to Add MAC Addresses of Mesh Access Points to the Controller Filter List
Using the controller GUI, follow these steps to add a MAC filter entry for the access point on the
controller.
Step 1 Click Security > AAA > MAC Filtering to open the MAC Filtering page (see
Figure 8-7
Click New to open the MAC Filters > New page (see
Step 2
Figure 8-8
In the MAC Address field, enter the MAC address of the mesh access point.
Step 3
Note
Step 4 From the Profile Name drop-down box, choose Any WLAN.
Cisco Wireless LAN Controller Configuration Guide
8-12
MAC Filtering Page
MAC Filters > New Page
For 1522 and 1524 outdoor mesh access points, enter the BVI MAC address of the mesh access
point into the controller as a MAC filter. For 1130 and 1240 indoor mesh access points, enter the
Ethernet MAC address. If the required MAC address does not appear on the exterior of the mesh
access point, enter the following command from the access point console to determine the BVI
and Ethernet MAC addresses: sh int | i Hardware.
Chapter 8 Controlling Mesh Access Points
Figure
Figure 8-8).
8-7).
OL-17037-01