Cisco 2100 Series Configuration Manual page 244

Configuring and Applying Access Control Lists
Figure 5-30
In the Access Control List Name field, enter a name for the new ACL. You can enter up to 32
Step 4
alphanumeric characters.
Step 5 Click Apply. When the Access Control Lists page reappears, click the name of the new ACL.
When the Access Control Lists > Edit page appears, click Add New Rule. The Access Control Lists >
Step 6
Rules > New page appears (see
Figure 5-31
Follow these steps to configure a rule for this ACL:
Step 7
The controller supports up to 64 rules for each ACL. These rules are listed in order from 1 to 64. In
a.
the Sequence field, enter a value (between 1 and 64) to determine the order of this rule in relation
to any other rules defined for this ACL.
Note
From the Source drop-down box, choose one of these options to specify the source of the packets to
b.
which this ACL applies:
•
•
Cisco Wireless LAN Controller Configuration Guide
5-56
Access Control Lists > New Page
Figure
Access Control Lists > Rules > New Page
If rules 1 through 4 are already defined and you add rule 29, it is added as rule 5. If you add
or change a sequence number for a rule, the sequence numbers for other rules adjust to
maintain a contiguous sequence. For instance, if you change a rule's sequence number from
7 to 5, the rules with sequence numbers 5 and 6 are automatically reassigned as 6 and 7,
respectively.
Any—Any source (This is the default value.)
IP Address—A specific source. If you choose this option, enter the IP address and netmask of
the source in the edit boxes.
5-31).
Chapter 5 Configuring Security Solutions
OL-17037-01