Cisco 2100 Series Configuration Manual page 642

Configuring Auto-Anchor Mobility
To create a new mobility anchor for the WLAN or wired guest LAN, enter one of these commands:
3.
Note
Note
To delete a mobility anchor for the WLAN or wired guest LAN, enter one of these commands:
4.
Note
Note
To save your settings, enter this command:
5.
save config
To see a list and status of controllers configured as mobility anchors for a specific WLAN or wired
6.
guest LAN, enter this command:
show mobility anchor {wlan | guest-lan} {wlan_id | guest_lan_id}
Note
For example, information similar to the following appears for the show mobility anchor command:
Mobility Anchor Export List
WLAN ID
GLAN ID
Cisco Wireless LAN Controller Configuration Guide
12-24
config mobility group anchor add {wlan | guest-lan} {wlan_id | guest_lan_id}
•
anchor_controller_ip_address
config {wlan | guest-lan} mobility anchor add {wlan_id | guest_lan_id}
•
anchor_controller_ip_address
The wlan_id or guest_lan_id must exist and be disabled, and the
anchor_controller_ip_address must be a member of the default mobility group.
Auto-anchor mobility is enabled for the WLAN or wired guest LAN when you configure the
first mobility anchor.
config mobility group anchor delete {wlan | guest-lan} {wlan_id | guest_lan_id}
•
anchor_controller_ip_address
config {wlan | guest-lan} mobility anchor delete {wlan_id | guest_lan_id}
•
anchor_controller_ip_address
The wlan_id or guest_lan_id must exist and be disabled.
Deleting the last anchor disables the auto-anchor mobility feature and resumes normal
mobility for new associations.
The wlan_id and guest_lan_id parameters are optional and constrain the list to the anchors
in a particular WLAN or guest LAN. To see all of the mobility anchors on your system, enter
show mobility anchor.
IP Address
1 10.50.234.2
1 10.50.234.6
2 10.50.234.2
2 10.50.234.3
IP Address
1 10.20.100.2
2 10.20.100.3
Chapter 12 Configuring Mobility GroupsWireless Device Access
Status
UP
UP
UP
CNTRL_DATA_PATH_DOWN
Status
UP
UP
OL-17037-01