Using The Cli To Configure Dynamic Interfaces - Cisco 2100 Series Configuration Manual

Configuring Dynamic Interfaces

Using the CLI to Configure Dynamic Interfaces

Follow these steps to configure dynamic interfaces using the CLI.
Enter show interface summary to view the current dynamic interfaces.
Step 1
To view the details of a specific dynamic interface, enter show interface detailed
Step 2
operator_defined_interface_name.
Enter config wlan disable wlan_id to disable each WLAN that uses the dynamic interface for
Step 3
distribution system communication.
Enter these commands to configure dynamic interfaces:
Step 4
•
•
•
•
•
•
•
Step 5 Enter config wlan enable wlan_id to re-enable each WLAN that uses the dynamic interface for
distribution system communication.
Enter save config to save your changes.
Step 6
Step 7 Enter show interface detailed operator_defined_interface_name and show interface summary to
verify that your changes have been saved.
Note
Cisco Wireless LAN Controller Configuration Guide
3-18
config interface create operator_defined_interface_name {vlan_id | x}
config interface address operator_defined_interface_name ip_addr ip_netmask [gateway]
config interface vlan operator_defined_interface_name {vlan_id | 0}
config interface port operator_defined_interface_name physical_ds_port_number
config interface dhcp operator_defined_interface_name ip_address_of_primary_dhcp_server
[ip_address_of_secondary_dhcp_server]
config interface quarantine vlan interface_name vlan_id
Note Use this command to configure a quarantine VLAN on any interface.
config interface acl operator_defined_interface_name access_control_list_name
Note See Chapter 5 for more information on ACLs.
If desired, you can enter config interface delete operator_defined_interface_name to delete a
dynamic interface.
Chapter 3 Configuring Ports and Interfaces
OL-17037-01