Cisco 2100 Series Configuration Manual page 432

Optimizing RFID Tracking on Access Points
Click the name of the access point for which you want to configure monitor mode. The All APs > Details
Step 2
for page appears.
Step 3 From the AP Mode drop-down box, choose Monitor.
Click Apply to commit your changes.
Step 4
Click OK when warned that the access point will be rebooted.
Step 5
Click Save Configuration to save your changes.
Step 6
Click Wireless > Access Points > Radios > 802.11b/g/n to open the 802.11b/g/n Radios page.
Step 7
Hover your cursor over the blue drop-down arrow for the desired access point and choose Configure.
Step 8
The 802.11b/g/n Cisco APs > Configure page appears (see
Figure 7-20
To disable the access point radio, choose Disable from the Admin Status drop-down box and click
Step 9
Apply.
To enable tracking optimization on the radio, choose Enable from the Enable Tracking Optimization
Step 10
drop-down box.
From the four Channel drop-down boxes, choose the channels on which you want to monitor RFID tags.
Step 11
Note
Cisco Wireless LAN Controller Configuration Guide
7-60
802.11b/g/n Cisco APs > Configure Page
You must configure at least one channel on which the tags will be monitored.
Chapter 7 Controlling Lightweight Access Points
Figure 7-20).
OL-17037-01