Viewing Neighbor Statistics For An Access Point; Using The Gui To View Neighbor Statistics For An Access Point - Cisco 2100 Series Configuration Manual

Viewing Mesh Statistics and Reports
•

Viewing Neighbor Statistics for an Access Point

This section explains how to use the controller GUI or CLI to view neighbor statistics for a selected
access point. It also describes how to run a link test between the selected access point and its parent.

Using the GUI to View Neighbor Statistics for an Access Point

Using the controller GUI, follow these steps to view neighbor statistics for an access point.
Click Wireless > Access Points > All APs to open the All APs page (see
Step 1
Figure 8-20 All APs Page
To view neighbor statistics for a specific access point, hover your cursor over the blue drop-down arrow
Step 2
for the desired access point and choose Neighbor Information. The All APs > Access Point Name >
Neighbor Info page for the access point appears (see
Cisco Wireless LAN Controller Configuration Guide
8-44
Re-Association Successes 0
Re-Authentication Failures 0
Re-Authentication Timeouts 0
Re-Authentication Successes 0
To view the number of packets in the queue by type, enter this command:
show mesh queue-stats Cisco_AP
Information similar to the following appears:
Queue Type Overflows
---------- ---------
Silver 0
Gold 0
Platinum 0
Bronze 0
Management 0
Overflows—The total number of packets dropped because of queue overflow.
Peak Length—The peak number of packets waiting in the queue during the defined statistics time
interval.
Average Length—The average number of packets waiting in the queue during the defined statistics
time interval.
Peak length Average length
----------- --------------
1 0.000
4 0.004
4 0.001
0 0.000
0 0.000
Figure
Chapter 8 Controlling Mesh Access Points
Figure 8-20).
8-21).
OL-17037-01