Using The Gui To Authorize Access Points - Cisco 2100 Series Configuration Manual

Autonomous Access Points Converted to Lightweight Mode
To view details about the access points that are provisioned using LSC, enter this command:
Step 10
show certificate lsc ap-provision
Information similar to the following appears:
LSC AP-Provisioning........................... Yes
Provision-List................................ Present
Idx
---
1

Using the GUI to Authorize Access Points

Using the controller GUI, follow these steps to authorize access points.
Click Security > AAA > AP Policies to open the AP Policies page (see
Step 1
Figure 7-6
If you want the access point to accept self-signed certificates (SSCs), manufactured-installed certificates
Step 2
(MICs), or local significant certificates (LSCs), check the appropriate check box.
If you want the access points to be authorized using a AAA RADIUS server, check the Authorize MIC
Step 3
APs against auth-list or AAA check box.
If you want the access points to be authorized using an LSC, check the Authorize LSC APs against
Step 4
auth-list check box.
Click Apply to commit your changes.
Step 5
Follow these steps to add an access point to the controller's authorization list:
Step 6
a.
b.
Cisco Wireless LAN Controller Configuration Guide
7-22
Mac Address
------------
00:18:74:c7:c0:90
AP Policies Page
Click Add to access the Add AP to Authorization List area.
In the MAC Address field, enter the MAC address of the access point.
Chapter 7 Controlling Lightweight Access Points
Figure 7-6).
OL-17037-01