Controlling Lightweight Access Points - Cisco 2100 Series Configuration Manual

Controlling Lightweight Access Points

This chapter describes the Cisco lightweight access points and explains how to connect them to the
controller and manage access point settings. It contains these sections:
Access Point Communication Protocols, page 7-2
•
Configuring Global Credentials for Access Points, page 7-5
•
Configuring Authentication for Access Points, page 7-9
•
Embedded Access Points, page 7-14
•
Autonomous Access Points Converted to Lightweight Mode, page 7-16
•
• Cisco Workgroup Bridges, page 7-34
• Configuring Backup Controllers, page 7-41
• Configuring Failover Priority for Access Points, page 7-46
Configuring Country Codes, page 7-49
•
Migrating Access Points from the -J Regulatory Domain to the -U Regulatory Domain, page 7-55
•
Using the W56 Band in Japan, page 7-58
•
Dynamic Frequency Selection, page 7-58
•
Optimizing RFID Tracking on Access Points, page 7-59
•
Configuring Probe Request Forwarding, page 7-62
•
Retrieving the Unique Device Identifier on Controllers and Access Points, page 7-63
•
Performing a Link Test, page 7-64
•
Configuring Link Latency, page 7-67
•
Configuring Power over Ethernet, page 7-70
•
• Configuring Flashing LEDs, page 7-74
• Viewing Clients, page 7-74
OL-17037-01
C H A P T E R
Cisco Wireless LAN Controller Configuration Guide
7
7-1