Using The Gui To Perform A Link Test - Cisco 2100 Series Configuration Manual

Wireless lan controller
Hide thumbs Also See for 2100 Series:
Table of Contents

Advertisement

Chapter 7
Controlling Lightweight Access Points
response packet. Both the link-test requestor and responder roles are implemented on the access point
and controller. Therefore, not only can the access point or controller initiate a link test to a CCX v4 or
v5 client, but a CCX v4 or v5 client can initiate a link test to the access point or controller.
The controller shows these link-quality metrics for CCX link tests in both directions (out: access point
to client; in: client to access point):
The controller shows this metric regardless of direction:
The controller software supports CCX versions 1 through 5. CCX support is enabled automatically for
every WLAN on the controller and cannot be disabled. The controller stores the CCX version of the
client in its client database and uses it to limit the features for this client. If a client does not support
CCXv4 or v5, the controller performs a ping link test on the client. If a client supports CCXv4 or v5, the
controller performs a CCX link test on the client. If a client times out during a CCX link test, the
controller switches to the ping link test automatically. See the
section on page 6-39
CCX is not supported on the AP1030.
Note
Follow the instructions in this section to perform a link test using either the GUI or the CLI.

Using the GUI to Perform a Link Test

Follow these steps to run a link test using the GUI.
Step 1
Click Monitor > Clients to open the Clients page (see
OL-17037-01
Signal strength in the form of RSSI (minimum, maximum, and average)
Signal quality in the form of SNR (minimum, maximum, and average)
Total number of packets that are retried
Maximum retry count for a single packet
Number of lost packets
Data rate of a successfully transmitted packet
Link test request/reply round-trip time (minimum, maximum, and average)
for more information on CCX.
"Configuring Cisco Client Extensions"
Figure
7-23).
Cisco Wireless LAN Controller Configuration Guide
Performing a Link Test
7-65

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4400 series

Table of Contents