Using The Gui To Configure Country Codes - Cisco 2100 Series Configuration Manual

Configuring Country Codes
You can configure country codes through the controller GUI or CLI.

Using the GUI to Configure Country Codes

Follow these steps to configure country codes using the GUI.
Follow these steps to disable the 802.11a and 802.11b/g networks:
Step 1
a.
b.
c.
d.
e.
f.
Step 2 Click Wireless > Country to open the Country page (see
Figure 7-18
Check the check box for each country where your access points are installed.
Step 3
If you checked more than one check box in Step 3, a message appears indicating that RRM channels and
Step 4
power levels are limited to common channels and power levels. Click OK to continue or Cancel to
cancel the operation.
Step 5 Click Apply to commit your changes.
Cisco Wireless LAN Controller Configuration Guide
7-50
If an access point was already set to a higher legal power level or is configured manually,
Note
the power level is limited only by the particular country to which that access point is
assigned.
Click Wireless > 802.11a/n > Network.
Uncheck the 802.11a Network Status check box.
Click Apply to commit your changes.
Click Wireless > 802.11b/g/n > Network.
Uncheck the 802.11b/g Network Status check box.
Click Apply to commit your changes.
Country Page
Chapter 7 Controlling Lightweight Access Points
Figure 7-18).
OL-17037-01