Using The Cli To Configure Enhanced Distributed Channel Access; Using Management Over Wireless; Using The Gui To Enable Management Over Wireless; Using The Cli To Enable Management Over Wireless - Cisco 2100 Series Configuration Manual

Using Management over Wireless

Using the CLI to Configure Enhanced Distributed Channel Access

Use this CLI command to configure 802.11 enhanced distributed channel access (EDCA) parameters to
support SpectraLink phones:
config advanced edca-parameters {svp-voice | wmm-default}
where
svp-voice enables SpectraLink voice priority (SVP) parameters and wmm-default enables wireless
multimedia (WMM) default parameters.
To propagate this command to all access points connected to the controller, make sure to disable and then
Note
re-enable the 802.11b/g network after entering this command.
Using Management over Wireless
The management over wireless feature allows operators to monitor and configure local controllers using
a wireless client. This feature is supported for all management tasks except uploads to and downloads
from (transfers to and from) the controller.
Before you can use management over wireless, you must properly configure the controller using one of
these sections:
•
•

Using the GUI to Enable Management over Wireless

Click Management > Mgmt Via Wireless to open the Management Via Wireless page.
Step 1
Check the Enable Controller Management to be accessible from Wireless Clients check box to
Step 2
enable management over wireless for the WLAN or uncheck it to disable this feature. The default value
is unchecked.
Click Apply to commit your changes.
Step 3
Click Save Configuration to save your changes.
Step 4
Use a wireless client web browser to connect to the controller management port or distribution system
Step 5
port IP address, and log into the controller GUI to verify that you can manage the WLAN using a
wireless client.

Using the CLI to Enable Management over Wireless

In the CLI, use the show network command to verify whether the management over wireless interface
Step 1
is enabled or disabled. If it is disabled, continue with Step 2. Otherwise, continue with Step 3.
To enable management over wireless, enter config network mgmt-via-wireless enable.
Step 2
Cisco Wireless LAN Controller Configuration Guide
5-52
Using the GUI to Enable Management over Wireless, page 5-52
Using the CLI to Enable Management over Wireless, page 5-52
Chapter 5 Configuring Security Solutions
OL-17037-01