Cisco 2100 Series Configuration Manual page 656

Configuring Hybrid REAP
Figure 13-3
Modify the configuration parameters for this WLAN using the various WLANs > Edit tabs. In our
h.
employee WLAN example, you would need to choose WPA+WPA2 for Layer 2 Security from the
Security > Layer 2 tabs and then set the WPA+WPA2 parameters.
Note
Note
Click Apply to commit your changes.
i.
Click Save Configuration to save your changes.
j.
Follow these steps to create a locally switched WLAN. In our example, this is the second WLAN
Step 2
(employee-local).
Follow the substeps in
a.
"employee-local."
b. When the WLANs > Edit page appears, modify the configuration parameters for this WLAN. In our
employee WLAN example, you would need to choose WPA+WPA2 for Layer 2 Security from the
Security > Layer 2 tabs and then set the WPA+WPA2 parameters.
Note
Cisco Wireless LAN Controller Configuration Guide
13-8
WLANs > Edit Page
Be sure to enable this WLAN by checking the Status check box on the General tab.
If NAC is enabled and you created a quarantined VLAN and want to use it for this WLAN,
be sure to select it from the Interface drop-down box on the General tab.
Step 1 to create a new WLAN. In our example, this WLAN is named
Be sure to enable this WLAN by checking the Status check box on the General tab. Also,
be sure to enable local switching by checking the H-REAP Local Switching check box on
the Advanced tab. When you enable local switching, any hybrid-REAP access point that
advertises this WLAN is able to locally switch data packets (instead of tunneling them to the
controller).
Chapter 13 Configuring Hybrid REAPWireless Device Access
OL-17037-01