Using The Gui To Configure Ipv6 Bridging - Cisco 2100 Series Configuration Manual

Configuring WLANs
Figure 6-15
Cisco Unified
CallManager
Voice WLAN

Using the GUI to Configure IPv6 Bridging

Follow these steps to configure a WLAN for IPv6 bridging using the GUI.
Click WLANs to open the WLANs page.
Step 1
Click the ID number of the desired WLAN to open the WLANs > Edit page.
Step 2
Click the Advanced tab to open the WLANs > Edit (Advanced tab) page (see
Step 3
Cisco Wireless LAN Controller Configuration Guide
6-38
IPv6 Bridging and IPv4 Web Authentication
Cisco Unified
Unity server
U
Si
Data WLAN
IPv6 Client - Traffic is bridged
The Security Policy Completed field in both the controller GUI and CLI shows "No for IPv4
Note
(bridging allowed for IPv6)" until web authentication is completed. You can view this field
from the Clients > Detail page on the GUI or from the show client detail CLI command.
Chapter 6
WCS
Splash page
Data WLAN
IPv4 Client - Web authentication
Configuring WLANsWireless Device Access
Figure 6-16).
OL-17037-01