Cisco 2100 Series Configuration Manual page 613

Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Figure 11-15
Choose one of these options from the Pico Cell Mode drop-down box:
Step 3
Disable—Disables pico cell mode. This is the default value.
•
V1—Enables pico cell mode version 1. This option is designed for use with legacy Airespace
•
products (those released prior to Cisco's acquisition of Airespace). Cisco recommends that you
choose V2 if you want to enable pico cell mode.
• V2—Enables pico cell mode version 2. Choose this option if you want to adjust the pico cell mode
parameters to optimize network performance in high-density areas, where all the clients support
high density.
If you chose V2 in
Step 4
Rx Sensitivity Threshold, CCA Sensitivity Threshold, and Transmit Power (see
Figure 11-16
Use the information in
OL-17037-01
802.11a > Pico Cell Page
Step 3, the 802.11a (or 802.11b/g) > Pico Cell page displays three configurable fields:
802.11a > Pico Cell Page with Pico Cell Mode V2 Parameters
Table 11-3 to adjust the values of these parameters as necessary.
Cisco Wireless LAN Controller Configuration Guide
Configuring Pico Cell Mode
Figure 11-16).
11-43