Cisco 2100 Series Configuration Manual page 5

Configuring Controller SettingsWireless Device Access
4
C H A P T E R
OL-17037-01
Using the CLI to Configure the Management, AP-Manager, Virtual, and Service-Port Interfaces
Using the CLI to Configure the Management Interface
Using the CLI to Configure the AP-Manager Interface
Using the CLI to Configure the Virtual Interface
Using the CLI to Configure the Service-Port Interface
Configuring Dynamic Interfaces
Using the GUI to Configure Dynamic Interfaces
Using the CLI to Configure Dynamic Interfaces
Configuring Ports
3-19
Configuring Port Mirroring
Configuring Spanning Tree Protocol
Using the GUI to Configure Spanning Tree Protocol
Using the CLI to Configure Spanning Tree Protocol
Enabling Link Aggregation
Link Aggregation Guidelines
Using the GUI to Enable Link Aggregation
Using the CLI to Enable Link Aggregation
Using the CLI to Verify Link Aggregation Settings
Configuring Neighbor Devices to Support LAG
Configuring a 4400 Series Controller to Support More Than 48 Access Points
Using Link Aggregation
Using Multiple AP-Manager Interfaces
Using the Configuration Wizard
Before You Start
4-2
Resetting the Device to Default Settings
Resetting to Default Settings Using the CLI
Resetting to Default Settings Using the GUI
Running the Configuration Wizard on the CLI
Using the AutoInstall Feature for Controllers Without a Configuration
Overview of AutoInstall
Obtaining an IP Address Through DHCP and Downloading a Configuration File from a TFTP
Server
4-7
Selecting a Configuration File
Example of AutoInstall Operation
Managing the System Date and Time
Configuring an NTP Server to Obtain the Date and Time
Configuring the Date and Time Manually
3-16
3-16
3-18
3-22
3-23
3-29
3-32
3-33
3-34
3-34
3-34
3-35
3-35
4-2
4-3
4-3
4-3
4-4
4-6
4-8
4-9
4-10
4-10
Cisco Wireless LAN Controller Configuration Guide
3-13
3-14
3-14
3-15
3-24
3-28
3-34
4-1
4-6
4-10
Contents
3-13
v